Through My Eyes

photography,crafts,lifestyle

Dragonfly

If you are wondering what to do with those gemstones you may have collected over the years, this may be the craft for you. Some people spend a lot of time and money on one piece buy I found that really takes the fun out of it.

The object is to use your gemstone as a guide. I usually lay it on a piece of paper and trace around it. Then I start with at least a 16 ga wire and lay it over the line I just drew leaving about 4″ at the top to create the bezel (the hole you run your chain through). In fact I usually fold the length of wire in half leaving about a half inch loop and twist it several times around creating the bezel.

Now that you have the bezel created, you take one side and lay it down to the bottom center. Take the opposite wire and do the same thing. Twist both wires together. In order for your stone to rest on your wire, you will need to create a basket by criss-crossing your wire from on the side of your frame to the other. Set your ston on top of the wire basket just created. Taking the wire from the opposite side you will now weave the wire over the top of the stone and pulling tightly as you go weave the ends around exiting wire and end with a small loop or if a lot is let cut with your wire cutters and then make your loop. With your flat needle nose pliers, you want to flatten the loop in a location where you won’t feel a scratch from the end of the wire. Make sure all of your wires are tight and your stone won’t move.

The piece above is a larger piece and more of a sculpture. You can wear it like oversized pieces, or you can lay it on its side for a paperweight. The wire was a little too stiff for this project.

Basic tools needed are flat needle nose pliers, round needle nose pliers, wire cutters, and a wire of choice. I basically use 16 – 18 ga wire for framing and the 22ga to wrap the larger wires.

You can find videos on YouTube for basic instructions. I recommend Fire Mountain Gems for the wire and gemstones. The tools you can find at Harbor Freight or your local hardware store.

I used to only use sterling silver, but since it is now harder to get, I use more copper. Sometimes, you can even find the larger ga wire at your hardware store, but it’s rare.

It’s not hard to do but does require some patience. Once you have gotten the basics down, you can try adding beads and more wire creations.

Have a great week.

Posted in

Leave a Reply